Two compressor names come up again and again on merchant ships: Sperre, for the main air compressors that fill the starting air receivers, and Tamrotor, for the screw compressors that supply working air. They do different jobs and wear in different ways, so the spares you order for each are different too. This guide covers the parts that matter most for both, and what to send your supplier to get the right part the first time. For a general overview of compressor spares, see our ship air compressor spares guide.
Sperre main air compressors
Sperre, a Norwegian maker, builds two-stage piston compressors, most of them for 30 bar starting air. On ships in service you will often find the water-cooled HV2 range, such as the HV2/200 and HV2/240, and the air-cooled HL2 range, such as the HL2/77A, HL2/90A and HL2/105A. Newer ships may have the later X-range, in water-cooled and air-cooled versions.
The spares ordered most often for Sperre compressors are:
- Suction and delivery valves for the low and high pressure stages, or the valve plates, springs and seats to overhaul them.
- Piston rings, pistons and cylinder liners, which wear with running hours and cause low output and oil carry-over.
- Connecting rod and main bearings, and gudgeon pin bushes.
- Intercooler and aftercooler parts, including cooler tube stacks on water-cooled units.
- Safety valves, unloader parts and complete gasket kits.
Sperre models have a long service life, and many older HV2 units are still running. For these, a used or reconditioned original valve or a complete compressor block is often the fastest and most cost-effective fix.
Tamrotor screw compressors
Tamrotor Marine Compressors, known today as TMC, makes oil-lubricated screw compressors, mostly for working air and control air on board. Models such as the EM 28-8 and EMH 35-10 are common in engine rooms. A screw compressor has fewer wearing parts than a piston unit, but it depends on clean oil and working filters.
The spares ordered most often for Tamrotor compressors are:
- Service parts: air filter, oil filter and oil separator element, replaced at fixed running-hour intervals.
- Valves: inlet or unloader valve, minimum pressure valve and thermostatic valve.
- Shaft seal and bearings, and at higher running hours the complete screw element (airend).
- Oil cooler, drive coupling and belts, and sensors or controller parts on automatic units.
When the screw element itself is worn, replacing it with a used or reconditioned element, or replacing the whole compressor, usually costs far less than a new unit.
Used, reconditioned or new
Used and reconditioned original maker compressors and major parts, such as blocks, screw elements and coolers, suit older ships and standby units. Reconditioned units are rebuilt with new wear parts and tested before dispatch. New spares, OEM or quality equivalents, are the best choice for filters, seals, rings, valve parts and gaskets.
What to send your supplier
- A photo of the nameplate showing maker, model and serial number
- Part numbers from the maker’s spare parts list, or the service kit you need
- Running hours, if you need an overhaul kit
- Quantity, vessel name or IMO number and the delivery port
How AMAF Marine can help
AMAF Marine supplies marine air compressors and spares, including Sperre main air compressors such as the HV2/240 and HL2/120, and Tamrotor screw compressors such as the EMH 35-10 EANA and EM 28-8 EANA. We offer used and reconditioned original maker equipment, as well as new spares (OEM and quality equivalents). Compressors are tested before dispatch and ship from our warehouse to any port.
Send us your nameplate photo and we will quote within 48 hours.



